Estimated, no exact match found

Split air conditioner outdoor condenser unit

Lennox (exact model not visible)

Best on a bigger screen. Blueprints are detailed, so they’re easier to explore on a laptop or desktop. Tap a pin to see what that part is.

Generated blueprint render

Drag or tilt your phone to explore · tap a number to inspect a part

Parts

14 components

1

Top cover panel

estimated

Sheet steel lid that closes the top of the unit and keeps rain and debris off the compressor and electronics.

Powder coated galvanized steel

2

Condenser coil

estimated

Copper tubes with aluminum fins that release the heat pulled from the house into the outside air.

Copper tube, aluminum fins

3

Inverter rotary compressor

estimated

The heart of the system: pumps and compresses refrigerant, and its variable speed inverter drive adjusts output to the cooling load.

Hermetic rotary, variable speed

4

Fan motor

estimated

Electric motor that spins the fan blade to pull air across the condenser coil.

Brushless DC motor

5

Axial fan blade

estimated

Propeller that moves a large volume of air through the coil and out the front grille.

Molded plastic

6

Front panel

estimated

Main front casing with the round fan opening; supports the fan and directs the airflow out.

Powder coated steel

7

Fan guard grille

estimated

Round wire guard over the fan outlet that keeps hands and objects away from the spinning blade.

Coated steel wire

8

Rear coil guard

estimated

Wire mesh that protects the delicate coil fins from impacts while letting air through.

Coated steel wire

9

Inverter control board

estimated

Electronics that run the compressor and fan speed, read the sensors and talk to the indoor unit.

PCB with inverter power stage

10

Electrical box and reactor

estimated

Metal enclosure under the control board holding the power components and choke that smooth the inverter's power.

Steel enclosure

11

Refrigerant piping

estimated

Copper lines that carry refrigerant between the compressor, coil and service valves.

Copper

12

Side panel

estimated

Removable service panel that covers the electrical and valve side of the unit.

Powder coated steel

13

Base pan

estimated

Steel tray everything mounts to; it also drains rain and condensate.

Galvanized steel

14

Anti vibration mounting feet

estimated

Brackets with rubber isolators that hold the unit down and stop compressor vibration reaching the wall or pad.

Steel with rubber bushings

What’s inside your stuff?

Snap a photo and get a blueprint like this in about 3 minutes.

Try Teardown